Turn Off Display After and the Put The Computer to Sleep Settings Problem

rmstern53

New member
Nov 29, 2010
35
0
0
I have a Surface Pro 3 and am unable to independently set the ?Turn Off Display After? and the ?Put The Computer to Sleep? settings different from each other when plugged in to power. When I change them and save them to different settings, they both revert back to the same setting the next time I check on them. I would like Turn Off The Display set to 20 minutes and Put the Computer to Sleep set to Never when connected to power.
Any ideas, thanks in advance.
 
Thanks for the response, much appreciated. It would be nice if MS would allow you to control the display while leaving Connected Standby on.......
 
I know, I'm not sure where the limitation is. I'm hoping it's not hardware limitation to be able to have the ability to keep CS enabled and also be able to turn off the screen. The downside for me is that I have 3 other monitors plugged in and the monitors never go into sleep mode with CS enabled and the device never set to power off/sleep, so they are just burning electricity when they should go in standby mode when the device isn't being used.
 

Members online

Forum statistics

Threads
339,487
Messages
2,262,511
Members
428,761
Latest member
Johnnybrewse