Hi guys,
So I'm pushing a load of new surface devices out in the next week or so.
As part of the initial setup on each device, I have to configure one drive.
So this is really simple, but really time consuming when i have to do it 300 times over.
So at the minute, when i open onedrive, i get this screen...
I have to put in the users email address, click next twice and then close the window.
Thats it... onedrive is set up and good to go.
I would really like to automate this bit of the process, but have thusfar had no success doing so.
Is anyone aware of how i might go about doing that?
I was hoping it would be a case of injecting a few Reg values or calling the exe with a paramater or something.
Thanks in advance
So I'm pushing a load of new surface devices out in the next week or so.
As part of the initial setup on each device, I have to configure one drive.
So this is really simple, but really time consuming when i have to do it 300 times over.
So at the minute, when i open onedrive, i get this screen...
I have to put in the users email address, click next twice and then close the window.
Thats it... onedrive is set up and good to go.
I would really like to automate this bit of the process, but have thusfar had no success doing so.
Is anyone aware of how i might go about doing that?
I was hoping it would be a case of injecting a few Reg values or calling the exe with a paramater or something.
Thanks in advance