Its not about audio quality, its about output volume.
Do you mistmatch output volume of sweedish firmware whit another random EU firmware?
Is sweedish firmware louder than other?
Thanks.
Sent from my RM-821_eu_euro1_276 using Board Express
Ok, i will test that firmware later and give a feedback about that.Let's say this way .... English (GB CV) has lower output level, for example, as Swedish one ... I do not know them all - so far, I have tried 4 different country variety ...
... good enough but if you're a real audiophile then I can see why it wouldn't be good enough. Then again, you would also have much better headphones so the difference would probably be less.
You have to make sure the headphone jack is fully inserted.
Use more than one set of headphones when evaluating the sound quality. It's the plug that goes into the phone that makes the difference..
I use Sennheiser IE80's and I wasn't impressed with my Lumia 920's sound quality after coming from an iPhone. But then again, I used a Sony Ericsson before that and was disappointed with the iPhone. You'll get used to the sound signature. The only big gripe for me is the volume is still too low even at 30/30. I don't like using EQ or Dolby, as it ruins the music and the EQ does nothing to increase the volume.
It's not my fault you have the ear-drums of a 4 year old girl. As I said before, the iPhone 4S was very much louder. I couldn't listen to that at full volume at all. The Lumia 920 is like a fart in a hurricane in comparison. Maybe its an issue with my phone though.
iphones and SG3 are known to have average sound.nah its more quiet then say the sgs3 or the iphone4 I used , sund quality not as good either , I think the sgs3 and iphones might have a better dsp chip in them though , I know the sgs3 uses a wolfson dsp chip for audio and there are many hacks and music apps to help get the best out of it , its another reason I may switch back to the sgs3 :-/
everyones hearing is different though but gsm arena did rate the 920 below average for a flagshiop handset in audio output via there tests