Torx size?

[kong u]

Does anybody know what size the torx screws are on the base of the 920?

Thought I read somewhere that it was T5 or T6 so I went and ordered some but theyre not the right size, too big.

If anybody knows the exact size head that would be sweet.

Thanks

 

[ttsoldier]

T2 , T4 and T5

 

[phirefly]

T5 on the bottom of the phone.

 

[MS_SURVEYOR]

Here's a video on How to take the Nokia Lumia 920 apart - for the DIY crowd.

 

[HIllste1]

Torx + Size 5 M2.5 x 9.7 is exactly what called out in the Repair Manual.

 

[920Walker]

The torx tool bit size is probably T-5.

M2.5 is the screw's metric thread diameter and 9.7 is the length, all in mm.

 

[kong u]

Just watched the DIY video and the poster says they're T5 screws, but according to the torx set that I bought, they're not. The set ranges from T5-T10 and T5 is way too big.

Unless the screwdriver set I bought was wrong then maybe phones vary. I'm from the UK and it sounds like the poster is too so I'm stumped!

 

[920Walker]

I just checked too. Way smaller than T-5. I have a micro screwdriver set with tiny torx buts and even the smallest doesn't fit.

Edit: It is T5. .055", 1.40mm. The smallest in my micro screwdriver kit was T6 and I found another micro kit i purchased with even smaller torx bits. The biggest being t5, and it fits.

 

[palandri]

On my Nokia N8 it was a T4 I found one on Amazon, but it took like 2 weeks for the company to mail it.

 

[ttsoldier]

I just checked too. Way smaller than T-5. I have a micro screwdriver set with tiny torx buts and even the smallest doesn't fit.

T2 , T4 and T5

...

 

[Rhody#WP]

I got my 920 open, but I can't separate the motherboard from the screen. The screw seems way too tiny. I have a T2 and an even smaller screw driver (T1 or hex 1.5?), and they're both too big. Does anybody know what size the screw is?

 

[thejaredhuang]

I guarantee its a T2 unless someone else messed with your phone. I've replaced the digitizer on 5 920s and I've only used T5s and T2s for assembly/diassembly.

 

[Rhody#WP]

I guarantee its a T2 unless someone else messed with your phone. I've replaced the digitizer on 5 920s and I've only used T5s and T2s for assembly/diassembly.

It was a T1.

Edit: For some reason I needed a T1 to get the screws out, but a T2 worked just fine putting them back in. You are correct, they are T2 screws.

 

[all area]

T2 , T4 and T5

 

[yeewiz]

T2 , T4 and T5

Correct!

 

[T Moore]

Husky 8 in 1 Torx Screwdriver Set
http://www.amazon.com/Husky-Torx-Sc...ag=hawk-future-20&ascsubtag=UUwpUvbUpU2422192
Cheaper at Home Depot

 

[Daniel Mathews1]

Does anybody know what size the torx screws are on the base of the 920?

Thought I read somewhere that it was T5 or T6 so I went and ordered some but theyre not the right size, too big.

If anybody knows the exact size head that would be sweet.

Thanks

T5 torx